This DB9 Female to RJ12 6P6C serial communication cable is designed for connecting a computer's RS232 serial port to the J5 serial communication port on compatible Kollmorgen P7000 stepper drives.
It provides a reliable RS232 communication connection for drive configuration, parameter adjustment, commissioning, and troubleshooting.
The cable is suitable for use with compatible Kollmorgen P7000 series stepper drive controllers and their configuration software.
Brand Compatibility: Kollmorgen
Compatible Series: P7000 Stepper Drive
Drive Connector: RJ12 6P6C Male
Computer Connector: DB9 Female (9-Pin)
Communication Interface: RS232
Port: J5 Serial Port
Communication Mode: Full-Duplex Serial Communication
Application: Drive Programming, Configuration and Troubleshooting
RJ12 6P6C – Kollmorgen P7000 J5
| RJ12 Pin | Signal | Function |
|---|---|---|
| Pin 1 | NC | Not Connected |
| Pin 2 | RX232 | Drive Serial Receive |
| Pin 3 | I/O RTN | Signal Ground |
| Pin 4 | NC | Not Connected |
| Pin 5 | TX232 | Drive Serial Transmit |
| Pin 6 | NC | Not Connected |
DB9 Female – Computer RS232
| DB9 Pin | Signal | Function |
|---|---|---|
| Pin 2 | RX | Serial Receive |
| Pin 3 | TX | Serial Transmit |
| Pin 5 | GND | Signal Ground |
According to the Kollmorgen P7000 reference manual:
Electrical Interface: RS232
Baud Rate: 19,200 bps
Data Bits: 8
Parity: Even
Stop Bits: 1
Flow Control: None
Communication: Full Duplex
Kollmorgen P7000 stepper drive configuration
J5 serial port communication
Motor drive parameter adjustment
Stepper drive commissioning
Industrial automation maintenance
Drive troubleshooting and diagnostics
Connect the DB9 female connector to a computer with an RS232 serial port.
Connect the RJ12 6P6C connector to the J5 serial port on the Kollmorgen P7000 drive.
Open compatible Kollmorgen configuration software.
Select the appropriate serial communication port.
Set the communication parameters according to the drive manual.
Establish communication to configure or monitor the drive.
This cable uses RS232 electrical signaling, not TTL UART or RS485.
Designed for the Kollmorgen P7000 J5 serial communication port.
Please verify the connector and pinout before ordering.
A computer without a physical DB9 serial port may require an additional USB-to-RS232 adapter.
Compatible configuration software is required for drive programming.
